Cummins fault code 286 is documented on this DiagTechPro library page for Cummins ISM CM871 (2007-09) engines, where it flags a Sae J1939 Multiplexing Configuration Error – Out Of Calibration condition (PID S231, SPN 639, FMI 13/13, Amber lamp). This 5-page PDF reproduces the manufacturer description, shop talk, component location and step-by-step troubleshooting so technicians can confirm and clear the code.
Cummins fault code 286 overview
Cummins defines this code as “SAE J1939 MULTIPLEXING CONFIGURATION ERROR – OUT OF CALIBRATION” on the SAE J1939 Multiplexing Configuration. Normally, switches, accelerators and other components are connected to the engine electronic control module (ECM) directly through individual wires. Multiplexing allows those same components to be hard wired to an original equipment manufacturer (OEM) vehicle electronic control unit (VECU) or transmission electronic control unit (ECU) in the cab. Then component values and states from components such as sensors, accelerators and switches can be transmitted from the OEM VECU to the Cummins® engine ECM over the SAE J1939 Data link.
Shop talk notes: Verify the electronic control module (ECM) calibration is correct. If necessary, recalibrate the ECM. This fault can occur when the ECM is set up properly (components enabled and OEM VECU source addressed correctly) to receive information from an OEM VECU, but the OEM VECU is actually transmitting a message that says that component is not available for multiplexing.
Official document details
| Brand | Cummins |
| Model coverage | Cummins ISM CM871 (2007-09); Cummins ISX CM871 (2007-09) |
| System / Group | SAE J1939 Multiplexing Configuration — ISM CM871 fault codes |
| Fault code | 286 (SPN 639, FMI 13/13) |
| Source | TruckFaultCodes.com Cummins fault code reference (© 2017) |
| Pages | 5 |
| File size | 0.3 MB |
| Format | |
| Language | English |
Document table of contents
- Fault code identification (PID, SPN, FMI, lamp)
- Description
- Shop Talk
- Component Location
- Troubleshooting Steps
Applicable truck models and engines
This document applies to Cummins ISM CM871 (2007-09); Cummins ISX CM871 (2007-09) equipped diesel engines that log Fault Code 286. Always confirm engine calibration and use a Cummins diagnostic tool such as INSITE to read live data before starting repairs. Full specifications are published on the Cummins official website.
Who needs this Cummins fault code 286 manual
Heavy-duty truck technicians, fleet workshops and owner-operators diagnosing an electronic control module warning on ISM CM871 engines will use this sheet to verify the fault before parts are replaced.
The full PDF is available in the DiagTechPro manuals library; a free account is required to download.
Related manuals library
Sản phẩm liên quan cho hãng này
Cùng brand theo taxonomy hiện có trong catalog WooCommerce.
Cummins Calterm Version 5.16 – Advanced ECM Control and Precision Tuning for Cummins Engines
Cummins INSITE 9.3 – The Essential Diagnostic Tool for Cummins Engines
Cummins InCal CE – The Calibration and Configuration Tool for Cummins Engines
