SPN 4363 FMI 3 — Detroit DD Series SCR outlet temp sensor circuit

SPN 4363 FMI 3 is the Detroit Diesel diagnostic trouble code set when the SCR outlet temperature sensor circuit fails high on DD Series (EPA 2007-current) engines. This 2-page troubleshooting sheet lists the fault definition, the relevant monitor or note data, and a numbered diagnostic routine that ends in the correct wiring or component repair. It is drawn from TruckFaultCodes.com (© 2017) and applies to the EPA10 / GHG14 emissions calibration.

Official document details

Brand Detroit Diesel
Model coverage DD Series engines (EPA 2007-current)
System / group DTCs — SCR outlet temperature sensor circuit
Suspect parameter (SPN) SPN 4363
Failure mode (FMI) SCR outlet temp sensor circuit failed high
Emissions calibration EPA10 / GHG14
Dash lamps MIL, CEL
Engine reaction 25% derate
Verification engine idle (1 minute)
Source / copyright TruckFaultCodes.com, © 2017
Pages 2
File size 0.3 MB
Format / language PDF / English

SPN 4363 FMI 3 table of contents

The SCR outlet temperature sensor connector is disconnected and inspected, then the resistance across pins 1 and 2 is compared to the sensor chart. If that is in range, voltage checks follow: greater than 3 volts on pin 2 indicates a short to power toward ACM pin 78, while a reading under 2.75 volts points to an open or high-resistance wire. Voltage present on pin 1 shows a short to power toward ACM pin 77; no voltage means the pin-77 wire is open.

  • Fault code header and description (always-enabled monitor)
  • Troubleshooting steps 1 to 6
  • Sensor resistance check (pins 1 and 2)
  • Pin-2 and pin-1 voltage diagnosis
  • Short-to-power versus open-circuit repair

Applicable truck models

This sheet is part of the DD Series diagnostic trouble code library and addresses the SCR outlet exhaust temperature sensor circuit. The SPN 4363 FMI 3 procedure applies to Detroit DD Series (EPA 2007-current) engines running the EPA10 / GHG14 calibration, and the same code index is cross-referenced under the Detroit Series 60 (DDEC VI, EPA 2007) fault-code set. For engine identification and warranty details, see the Detroit Diesel official site.

Who needs this SPN 4363 FMI 3 manual

It helps technicians decide between a failed sensor, a short to power and an open circuit on the SCR outlet temperature signal of Detroit DD Series trucks. The voltage thresholds pinpoint the exact ACM pin and wire to repair.

The full 2-page PDF is available in the DiagTechPro manuals library; a free account is required to download.

SPN 4363 FMI 3 — Detroit DD Series SCR outlet temp sensor circuit 1 / 2
SPN 4363 FMI 3 — Detroit DD Series SCR outlet temp sensor circuit - preview page 1 of 2
SPN 4363 FMI 3 — Detroit DD Series SCR outlet temp sensor circuit - page 2 is available after signing in
Free preview - 1 of 2 pages. Sign in to download the full PDF. Create a free account to download the full PDFNo credit card required · Instant download

Sản phẩm liên quan cho hãng này

Cùng brand theo taxonomy hiện có trong catalog WooCommerce.

This entry was posted in . Bookmark the permalink.
Telegram Telegram us WhatsApp WhatsApp us