SPN 4360 FMI 4 is the Detroit Diesel diagnostic trouble code set when the SCR inlet temperature sensor circuit fails low on DD Series (EPA 2007-current) engines. This 1-page troubleshooting sheet lists the fault definition, the relevant monitor or note data, and a numbered diagnostic routine that ends in the correct wiring or component repair. It is drawn from TruckFaultCodes.com (© 2017) and applies to the EPA10 / GHG14 emissions calibration.
Official document details
| Brand | Detroit Diesel |
|---|---|
| Model coverage | DD Series engines (EPA 2007-current) |
| System / group | DTCs — SCR inlet temperature sensor circuit |
| Suspect parameter (SPN) | SPN 4360 |
| Failure mode (FMI) | SCR inlet temp sensor circuit failed low |
| Emissions calibration | EPA10 / GHG14 |
| Dash lamps | MIL, CEL |
| Verification | engine idle (1 minute) |
| Source / copyright | TruckFaultCodes.com, © 2017 |
| Pages | 1 |
| File size | 0.2 MB |
| Format / language | PDF / English |
SPN 4360 FMI 4 table of contents
With the ignition off, the SCR inlet temperature sensor connector is disconnected and inspected for bent, spread or corroded pins. The ACM 120-pin connector is unplugged and the resistance measured between pin 2 on the harness side of the sensor connector and ground. Under 1K ohms means repairing the wire between pin 2 and ACM pin 76; a higher reading means replacing the sensor itself.
- Fault code header and description (always-enabled monitor)
- Troubleshooting steps 1 to 5
- Harness pin inspection
- Resistance-to-ground decision (wire versus sensor)
- Engine-idle verification
Applicable truck models
This sheet is part of the DD Series diagnostic trouble code library and addresses the SCR inlet exhaust temperature sensor circuit. The SPN 4360 FMI 4 procedure applies to Detroit DD Series (EPA 2007-current) engines running the EPA10 / GHG14 calibration, and the same code index is cross-referenced under the Detroit Series 60 (DDEC VI, EPA 2007) fault-code set. For engine identification and warranty details, see the Detroit Diesel official site.
Who needs this 4360 FMI 4 manual
It is written for technicians resolving a low-side SCR inlet temperature circuit fault on Detroit DD Series trucks. One resistance reading separates a shorted wire from a failed sensor and points to the exact ACM pin to repair.
The full 1-page PDF is available in the DiagTechPro manuals library; a free account is required to download.
Related manuals library
Sản phẩm liên quan cho hãng này
Cùng brand theo taxonomy hiện có trong catalog WooCommerce.
Detroit Diesel Reports 6.3
Detroit Reprogramming Station (DDRS) 7.11
DDDL Backdoor Password: A Comprehensive Guide
